2024年3月16日发(作者：)

Pair Button

(Fn + P)

Power Button

(Fn + F1)

Clean Button

(Fn + C)

Note: The SBW-97-TP ships from iKey with the internal

battery fully charged and ready to use out of the box.

Pairing Instructions

•

Insert the provided SBW-97-TP Dongle into

illuminate orange when charging and will turn

off when fully charged. In a fully discharged

state, the battery takes 5 hours to completely

recharge.

anticipated battery life is two weeks.

an open USB port on your computer. The

system will detect and install the appropriate

drivers. Once the SBW-97-TP Dongle has been

detected and properly installed by Windows

you are ready to pair the keyboard.

•

With average usage of the keyboard, the

•

In order to enter pairing mode, press the

Fn + P keys simultaneously and then release

both keys. The Scroll Lock/Pairing LED indica-

tor will flash blue until the keyboard pairs to

the SBW-97-TP Dongle. The operating system

will recognize the new keyboard and install

the needed drivers. No special drivers are

required to operate the keyboard. Upon suc-

cessful pairing the LED will turn off. If you do

not see the LED illuminate when attempting to

pair, you may have to charge the battery (see

charging instructions below).

Functionality and Features

•

To conserve power, the keyboard can be

turned off when not in use by pressing the

Fn + F1 keys simultaneously. All three LEDs

will flash once indicating the keyboard has

turned off. The same key combination will

then turn the power back on. Each time the

keyboard is powered off it will need to be

paired with the host again.

Charging Instructions

•

To charge the keyboard, insert the provided

•

To disable the keyboard for cleaning, press

the Fn + C keys simultaneously. The Scroll

Lock LED will continuously flash green indicat-

ing the keyboard is in clean mode. After

cleaning the keyboard press the Fn + C keys

again to reactivate keyboard. The LEDs will

stop flashing to indicate keyboard is active.

Micro USB charging cable into the back of the

keyboard and plug the other end of the cable

into a powered USB port on any computer.

The Caps Lock/Charging LED indicator will

• 1.800.866.6506

Signal Distance

The SBW-97-TP can function up to a distance

of 10 meters (~30 feet) from the host com-

puter. The signal may be lost if the keyboard

gets out of range, but the unit should start

working again if you move back within the 10

meter signal distance. If the unit still does not

work it may need to be re-paired.

SBW-97-TP Dongle

Other Keyboards/Mice

Our SBW-97-TP units will not interfere with

any other keyboard, mouse, or keyboard/

mouse combo that is plugged into the USB or

PS2 ports of the computer.

Notice: The changes or modifications not expressly approved by the

party responsible for compliance could void the user’s authority to

operate the equipment.

IMPORTANT NOTE: To comply with the FCC RF exposure compliance

requirements, no change to the antenna or the device is permitted. Any

change to the antenna or the device could result in the device exceeding

the RF exposure requirements and void user’s authority to operate the

device.

The Federal Communication Commission Radio Frequency Interference

Statement includes the following paragraph:

The equipment has been tested and found to comply with the limits for

a Class B Digital Device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction, may cause harmful interference to radio

communication. However, there is no grantee that interference will not

occur in a particular installation. If this equipment dose cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

The user should not modify or change this equipment without written

approval form D-Link Corporation. Modification could void authority to

use this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Lock Key Indicators

There are six LED indicators located at the

top of the keyboard. These are dual purpose

indicating LEDs.

•

The first LED is Num Lock and may also

indicate low power. When Num Lock is on

the LED will be green and when the battery

has low power the LED will blink red.

•

The second LED indicates Caps Lock and

Charging. Caps Lock is indicated by a green

LED and when the keyboard battery is being

charged the LED will be orange.

•

The third LED is the Scroll Lock and Pairing

LED. When Scroll Lock is on the LED will be

green. When the keyboard is put into paring

mode the LED will blink blue for two minutes

or until the keyboard pairs to a dongle.

Sleep Mode

After 10 seconds of inactivity, the unit will

go into Sleep Mode. This is a power saving

feature on the board that will put the board

in a low power state until needed again. To

wake the unit from sleep mode press any

key or use the touchpad. We recommend

pressing the space bar or using the touchpad

to prevent interference with any programs on

your computer.

Questions?

Contact

®

512.837.0283

800.866.6506

*************

©2012 iKey, Ltd. All rights reserved.