2024年3月24日发(作者：)

温控器接线图

POWER UP PROCEDURE启动程序

Verify all electrical connections have been properly made before applying power to

the instrument.

If the instrument is being powered for the first time, it may be desirable to disconnect

the controller output connections. The instrument will be into control following the

power up sequence and the output(s) may turn ON. During power up, a self-test

procedure is initiated during which all LED segments in the two front panel displays

appear and all LED indicators are ON. When the self-test procedure is complete, the

instrument reverts to normal operation如

果仪器首次被驱动的,它可能要断开控制器输出连接。仪

器会进入控制启动序列和后输出)可能打开。在启动期间,自测过程启动期间所有LED

。

自测过程完成后,仪

器返回正常的操作。

.

Note: A delay of about 3 seconds, when power is first applied, will be seen

before the displays light up

注意:延迟约3秒,当电源是第一次应用,将见过显示点亮

.

3.1.2 KEYPAD OPERATION

AUTO/MANUAL KEY

This key is used to:

1. Enter the Auto/Manual mode and vice versa.

2. Used to activate the Auto Tune mode.

3. Used to confirm a change in the Program mode.

自动/手动键

这把键是用来:

1。进入自动/手动模式,反之亦然。

2。用于激活自动调整模式。

3。用来确定程序模式的改变

SCROLL KEY

This key is used to:

1. Select adjustment of the ramping setpoint, if enabled.

2. Select a parameter to be viewed or adjusted.

3. Display enabled modes of operation.

4. Display a mode parameter value.

5. Advance display from a parameter value to the next parameter code.

6. Activate the Pre-tune mode.

7. With the DOWN key to view the current Hardware Definition Code setting

滚动键

这把键是用来:

1。如果启用,选择调整增加定位点。

2。选择查看一个参数或调整。

3。显示启用的操作模式。

4。显示一个模式参数值。

5。提前从参数值显示到下一个参数的代码

6。激活Pre-tune模式。

7。在查看当前硬件定义的关键代码设置

UP KEY

This key is used to:

1. Increase the displayed parameter value.

2. Increase setpoint.

3. With the DOWN key to enter Pre and Auto Tune mode.

上键

这把键是用来:

1。增加显示的参数值。

2。增加定位点。

3。用下键进入前和自动调整模式。

DOWN KEY

This key is used to:

1. Decrease the displayed parameter value.

2. Decrease setpoint.

3. With the UP key to enter the Pre and Auto Tune mode.