2023年12月6日发(作者：)
Q：如何对网关进行基本配置
A：以下是基本配置流程
（1） 设置WAN口IP
（2） 设置出口网关地址
（3） 设置线路
（4） 设置拨号规则
（5） 注册网守服务器
Login:root
Password: // 注释：密码centnet
Centnet Cos [Software Version V03.01.r4.330 For CNG300 4FXS]
Copyright (C) By 1999-2004 Centnet Technologies Co..Ltd All rights reserved.
Centnet>con
Please input the Password: // 注释：该处密码为空，直接回车
Centnet/Conf>
Centnet/Conf>sh e0 // 设置E0口IP地址
-------------------------------------------------------------------------
Interface IP_address IP_mask MAC
E0 192.168.0.48 255.255.255.0 04:ab:01:e0:19:77
-------------------------------------------------------------------------
Proxy : Disable
Hostname : Centnet@
tos : 5
DHCP : Disable
PPPoE : Disable
NAT : Disable
TCP port base : 30000
Range : 300
UDP port base : 5000
-------------------------------------------------------------------------
Centnet/Conf>e0
Centnet/Conf/E0>ip 192.168.0.77 255.255.255.0
Centnet/Conf/E0>qu
Centnet/Conf>sh e0
-------------------------------------------------------------------------
Interface IP_address IP_mask MAC
E0 192.168.0.77 255.255.255.0 04:ab:01:e0:19:77
-------------------------------------------------------------------------
Proxy : Disable
Hostname : Centnet@
tos : 5
DHCP : Disable
PPPoE : Disable
NAT : Disable TCP port base : 30000
Range : 300
UDP port base : 5000
-------------------------------------------------------------------------
Centnet/Conf>show route 注释：设置路由
destination mask gateway flags Refcnt Use Interface
--------------------------------------------------------------------------------
192.168.0.0 255.255.255.0 192.168.0.77 101 0 0 cpm0
192.169.4.0 255.255.255.0 192.169.4.245 101 0 0 motfec0
Centnet/Conf>route add default 192.168.0.1
Centnet/Conf>sh route
destination mask gateway flags Refcnt Use Interface
--------------------------------------------------------------------------------
0.0.0.0 0.0.0.0 192.168.0.1 103 0 0 cpm0
192.168.0.0 255.255.255.0 192.168.0.77 101 1 0 cpm0
192.169.4.0 255.255.255.0 192.169.4.245 101 0 0 motfec0
Centnet/Conf>
Centnet/Conf>sh line 注释：设置线路
The configuration of lines:----------------------------------------
lineNo. Type Status Mode AudioCode Nob Answer Prefix(called)
0 FXS IDLE Rel/UP G723/6 2 Normal T
1 FXS IDLE Rel/UP G723/6 2 Normal T
2 FXS IDLE Rel/UP G723/6 2 Normal T
3 FXS IDLE Rel/UP G723/6 2 Normal T
Centnet/Conf>line
Centnet/Conf/LineALL>ter
Centnet/Conf/LineALL>pre del t
Centnet/Conf/LineALL>qu
Centnet/Conf>wr
Writing data into flash
(343Bytes) Writen successfully.
Centnet/Conf>sh l 0
-------------------------------------------------------------------------
Line : 0 status : IDLE
-------------------------------------------------------------------------
type : FXS mode : Terminal
active : UP codec : G723/6 2
sce : Disable vad : Disable
answer : Normal dtmf : InBand
inVol(D) : 32 outVol(D) : 32
inVol(A) : 32 outVol(A) : 32
handdown time : 300 ms flash time : 350ms
sdtmf wait time : 1000 ms sdtmf interval : 150ms rdtmf time out : 30000ms rdtmf end time : 5000ms
faststart : Enable h245tunnel : Enable
busy check : Enable Invert check : Disable
round trip : Disable Faxmode : T38
faxrate : 14400 faxredundancy : 1
faxVolume : 6 dtmfVolume : 27
msd : Disable h245 timeout : Disable
handup time : 200 ms hotline :
billing : Disable JitterFactor : 7
display called : Disable findvoice : 0
card :
H323ID :
(calling)Number : ******
-------------------------------------------------------------------------
Centnet/Conf>line 0
Centnet/Conf/Line0>pre add 1001
Centnet/Conf/Line0>qu
Centnet/Conf>line 1
Centnet/Conf/Line1>pre add 1002
Centnet/Conf/Line1>qu
Centnet/Conf>line 2
Centnet/Conf/Line2>pre add 1003
Centnet/Conf/Line2>qu
Centnet/Conf>wr
Writing data into flash
(400Bytes) Writen successfully.
Centnet/Conf>sh line
The configuration of lines:----------------------------------------
lineNo. Type Status Mode AudioCode Nob Answer Prefix(called)
0 FXS IDLE Ter/UP G723/6 2 Normal 1001
1 FXS IDLE Ter/UP G723/6 2 Normal 1002
2 FXS IDLE Ter/UP G723/6 2 Normal 1003
3 FXS IDLE Ter/UP G723/6 2 Normal
Centnet/Conf>sh dial
Centnet/Conf>dial t 注释：设置拨号规则
Centnet/Conf/Dial T>qu
Centnet/Conf>wr
Writing data into flash
(441Bytes) Writen successfully.
Centnet/Conf>sh dial
----dial T---------------------------------------
Map : 0.0.0.0(0) Codec : g723/6 2
vad : Disable sce : Disable
dtmf : inband Faxmode : t38
Trip : Disable msd : Disable
Faststart : Enable H245tunnel : Enable
Alerttime(s) : 60
Timeout(s) : 60
dialmode : normal prefix : -1 + /
alertmode : Relay JitterFactor: 7
pstn : Disable
Centnet/Conf>sup
Please input the Password:
Password wrong
Please input the Password:
Centnet/Conf>h323
Centnet/Conf/H323>show
--H323 Settings-------------------------------------------
RAS port : 1719
RAS port base : 1719
RAS range : 6
Q931 port : 1720
Retry interval : 6
Retry times : 6
GateKeeper : Disable
Alternative GK : Disable
GateKeeper ID :
GateWay ID :
Card Number : 8
Card Password : 8
Aliase_name :
RAS password :
Prefix :
H323id :
Type : cisco
UpdtRtpRmtAddr : Enable
----------------------------------------------------------
Centnet/Conf/H323>h323id 12334
Centnet/Conf/H323>gk 222.111.244.10
Centnet/Conf/H323>GK Registration[36] UP!
Centnet/Conf/H323>show
--H323 Settings-------------------------------------------
RAS port : 1720 RAS port base : 1719
RAS range : 6
Q931 port : 1720
Retry interval : 6
Retry times : 6
GateKeeper : 222.111.244.10 1719(UP) 注释：服务器地址
Alternative GK : Disable
GateKeeper ID :
GateWay ID :
Card Number : 8
Card Password : 8
Aliase_name :
RAS password :
Prefix :
H323id : 12334 注释：服务器提供的H323ID
Type : cisco
UpdtRtpRmtAddr : Enable
----------------------------------------------------------
Centnet/Conf/H323>qu
Centnet/Conf/wr
发布评论