2024年5月11日发(作者：)

Downloaded from on 2011-02-11T16:03:46.

INCH-POUND

MIL-DTL-62474F

w/AMENDMENT 1

21 May 2008

SUPERSEDING

MIL-DTL-62474F

29 November 2007

DETAIL SPECIFICATION

LAMINATE: ARAMID-FABRIC-REINFORCED, PLASTIC

This specification is approved for use by all Departments and Agencies of the

Department of Defense.

1. SCOPE

1.1 Scope. This specification covers an aramid fabric-reinforced plastic laminate for use

in composite armor systems.

1.2 Classification. Laminates will be of the type and class specified (see 6.2):

Type 1 - Flat.

Type 2 - Molded.

Class A - Yarn used, nominal 1500 Denier, minimal 975 filaments. Basket weave

Class B - Yarn used, nominal 3000 Denier, minimal 1300 filaments. Basket weave

Class C - Yarn used, nominal 3000 Denier, minimal 1300 filaments. Plain weave

Class D* - Yarn used, nominal 3000 Denier, minimal 1300 filaments. Plain weave

*(low resin content variant)

Comments, suggestions, or questions on this document should be addressed to U.S. Army

Tank-automotive and Armaments Command, ATTN: AMSRD-TAR-E/CM/DM/STND, MS#

268 Warren, MI 48397-5000 or emailed to DAMI_STANDARDIZATION@

.

Since contact information can change, you may want to verify the currency of this address

information using the ASSIST Online database at .

AMSC N/A FSC 9330

DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.

Downloaded from on 2011-02-11T16:03:46.

MIL-DTL-62474F

w/AMENDMENT 1

1.3 Part or identifying number (PIN). The PIN to be used for laminate acquired to this

document is created as follows:

M 62474 - X X

Class (see 1.2)

A - Class A

B - Class B

C - Class C

D - Class D

Type (see 1.2)

1 - Type I

2 - Type II

Specification number

Prefix for military specification.

2. APPLICABLE DOCUMENTS

2.1 General. The documents listed in this section are specified in sections 3, 4 or 5 of

this specification. This section does not include documents cited in other sections of this

specification or recommended for additional information or as examples. While every effort has

been made to ensure the completeness of this list, document users are cautioned that they must

meet all specified requirements of documents cited in sections 3, 4 or 5 of this specification,

whether or not they are listed.

2.2 Government documents.

2.2.1 Specifications, standards, and handbooks. The following specifications, standards,

and handbooks form a part of this document to the extent specified herein. Unless otherwise

specified, the issues of these documents are those cited in the solicitation or contract.

DEPARTMENT OF DEFENSE STANDARDS

MIL-STD-662 - V50 Ballistic Test for Armor.

MIL-STD-810 - Environmental Test Methods and Engineering Guidelines.

(Copies of these documents are available online at /quicksearch/ or from

the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA

19111-5094.)

2